open mini netbook

open project of mini netbook, 7'' ARM netbook


You are not connected. Please login or register

Help Needed to Activate the COM Port on AK7802

View previous topic View next topic Go down  Message [Page 1 of 1]

gqsha


I attached 4 wires to CN1 as it is described in some posts here only to get the message "COM1 Open Failed,... COM12 Open Failed!" when I ran some program.

The connector can traced to pins 6-7 of AK7802 but they seem to malfunction.

Can anyone kindly drop some tips or solutions?

Thanks in advance!

gqsha


Hi, there

I have fixed the problem by swapping the wire TXD with RXD except that the mouse arrow is restricted to the bottom left-hand corner and cannot be moved.

I also tried the rear USB port which I hoped to convert to a serial port but the installation of the driver (PL-2303 for WINCE ARM) failed.

I begin to think that the Mininetbook is a piece of junk and useless.

Any advice will be appreciated.

Oto


Master
Master
CN1 i think is debug port and not COM.

Sponsored content


View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum